I see. Makes sense.
Interesting take. So is it your stance that a community should ban or retain folks based on what they've up/down voted? Seems like (if that's the case) you'd run into very little diversity of thought in most communities. Which is fine if that's the goal I guess.
Good to know for future prints. Thank you. This particular part of for a toy sword for my son, we're learning this hobby together so I appreciate the insight.
Thanks. I appreciate it
Oh ok. Thanks!
Printed this cylinder as part of a larger project and there's a horizontal line that runs up most of the part. Not bad enough to scrap the project but I'm curious if anyone can explain what causes this. Using an Ender 3 printing PLA, Cura slicer.
KFC is my favorite. We have a Korean spot called CM chicken near my house and it's always good. Stays crispy forever.
Lance: Look, you brought her here, and that means that you're giving her the shot. The day that I bring an OD-ing bitch over to your house, then I'll give her the shot. Give her the shot.