For real. Everytime I get in the shower I end up having to point the showerhead away and cower from the cold water and I could have just turned it on first?
this post was submitted on 19 Jun 2025
768 points (98.6% liked)
People Twitter
7436 readers
1407 users here now
People tweeting stuff. We allow tweets from anyone.
RULES:
- Mark NSFW content.
- No doxxing people.
- Must be a pic of the tweet or similar. No direct links to the tweet.
- No bullying or international politcs
- Be excellent to each other.
- Provide an archived link to the tweet (or similar) being shown if it's a major figure or a politician.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Sorry, you've met wealthy people, right...?
It's just dumb engineering to heat up a pipe the entire day for the 0.8% of the day you need it to be hot.
Heat pumps generally use a lot less power. Don't need to heat up much if it is already slightly hot.
Insulation + retaining heat means it isn't nearly as energy inefficient as you think.
They keep the water tanks heated all day, and not heating the pipes means they have to do more work as they are drained of more water to fill the length of pipe to the shower which will then lose that heat over the course the day, only to need the water heater to heat it back up again.
With enough insulation, anything can meet energy-efficiency standards. XD
It’s typically used for large complexes like campuses where the hot water is made en masse in one building and the loop goes around all the other buildings. Helps keep cost down (at construction) because you only need one giant water heater. Helps not have to wait 10 minutes to bring the hot water to your building. Energy still gets wasted but given the number of users, not that bad.
Have you read the previous comments? Because that's exactly what's implied.